Survey Instruments - Accessories for Sale

Features:

• Prevents Your Instrument from Going out of Level
• Reduces Set Up Time
• Light Weight, Compact and Easy to Carry
• Easy To Use
• Saves Time and Money
• Made in USA

1. Decide where you want your tripod legs to go
2. On frozen ground, snow, mud, gravel or asphalt, put the Sta-Level Foot in the spot you want the tripod leg to go and firmly push it down with your own foot.
3. On ice, always be careful. Make sure your Sta-Level Foot is going to hold on the ice and not slip when you put the instrument up. If the ice is really slick and hard, rough up the area or chip out a spot for each Sta-Level Foot.
4. If used properly, you will stay level even on the sunniest of days.
5. After you have finished that set-up, remove the tripod, pull up the Sta-Level Feet by the handles, loop them together and move to your next set-up.
6. The handles can be adjusted to suit your needs; loop them to the tripod, bind them together, or hang them from the instrument case.

FAQ

What is the Sta-Level Foot Used for?
The Sta-Level Foot is used to stabilize a Surveyor Tripod in adverse conditions. In snow it will help stop sinking, on asphalt and ice and mud it will help stop the tripod from slipping. The Sta-Level Foot has points on the bottom of it for slip control.

Is the Sta-Level Foot lightweight and easy to use?
Yes the Sta-Level Foot only weighs 4.7 oz. It has a handy bungee that helps with carrying it, hanging them up on equipment or in a building to store and good for placing the item on the ground exactly where you want it which makes it very easy to use.

Where does the tripod leg go on the Sta-Level Foot?
Place the Sta-Level Foot on the ground approximately where you would like to place your tripod. Place the tripod legs in the middle hole in the Sta-Level Foot. It is as easy as that.

Is Sta-Level Foot going to last?
The Sta-Level Foot has been weight tested. To test it yourself, put your tripod on the Sta-Level Foot and stand on tripod leg (this test is to be done at your own risk and at your own equipment risk). The Sta-Level Foot will withstand the weight.

What is the bungee used for?
The bungee is used to carry, hang or place the Sta-Level Foot where you want it.

How do I attach the bungee if it detaches from the Sta-Level Foot?
Place the end with a circle cut out in the middle on the left knob side of the Sta-Level Foot and press until the knob goes into the bungee circle. Attach the right side by pressing between the 2 end beads onto the right side notch.